Quantcast
Jump to content


Recommended Posts

Posted

5000 miles ago we installed a used engine with 65k in a vehicle. We also installed a new timing belt and tensioner at that time. The vehicle was towed in with a no start condition. Long story short, the timing belt had jumped and bent the valves. The engine supplier is off the hook because they require installer to replace the belt. Our insurance carrier said its not covered either. My argument is that it's a loss. I have to buy a new engine, pay our tech to replace it and loss of ability to do paying work for about 18hours. I've never had an insurance claim and now that I'm asking for one I'm told it is not covered. How can insurance companies get away with this. Anyone else had an experience like this?

  • Like 1
Posted

5000 miles ago we installed a used engine with 65k in a vehicle. We also installed a new timing belt and tensioner at that time. The vehicle was towed in with a no start condition. Long story short, the timing belt had jumped and bent the valves. The engine supplier is off the hook because they require installer to replace the belt. Our insurance carrier said its not covered either. My argument is that it's a loss. I have to buy a new engine, pay our tech to replace it and loss of ability to do paying work for about 18hours. I've never had an insurance claim and now that I'm asking for one I'm told it is not covered. How can insurance companies get away with this. Anyone else had an experience like this?

I've been through similar situations but I'm very cautious in regards to used engines.

Sounds like the supplier knows how to avoid issues on their end for sure! Unfortunately it sounds like this is a genuine comeback. Be it technician mistake or new part failure, unless there's something internal that caused it. I get very nervous in regards to large ticket used items.

I've asked my insurance agent about similar situations and get the "deer in headlight look" and "no that's not covered". I'm curious if any of the other folks have any knowledge of insurance plans that covers loss type situations.

 

Sent from my SCH-I605 using Tapatalk

Posted

My insurance doesn't pay for comebacks or technician mistakes that cause me money and work. Example: if my guy doesn't tighten a wheel and it damages the car - too bad I pay. If in the same situation the loose wheel flys off and hurts someone waiting in line for the bus then they will pay for the medical bills.

Posted

On a side note you probably won't lose too much cash, take some of the profit from the original job and put some valves in the broken engine. Have a different tech do the work. Its possible the tensioner was defective in which case the vendor might help you with a labor claim. I doubt the belt was defective. What is the vehicle?

Posted

We also installed a new timing belt and tensioner at that time.

The engine supplier is off the hook because they require installer to replace the belt.

What am I not understanding? You replaced the belt, why are they off the hook?

Posted

If we replaced it then its all on us. If we didn't as per their installation requirements it's on us. Either way they're off the hook.

Posted

Sounds like its time to find a new used parts supplier. I just got to eat an engine myself that I screwed up (very long story but it was my fault) so I know the pain. Lost all last months profit on that job...

Posted (edited)

Wow. I have never had to warranty a used engine (I know that sounds strange, keeping my fingers crossed still) but I would hope they would stand behind an engine with less then 5k on it.

 

Have you found out why the belt jumped? Once you find out then you can go to either the salvage yard or timing belt manufacture for help. I know my friends shop once had to deal with Gates over a defective waterpump that fried a timing belt.

 

I am not sure how your salvage yards are in your location, but here we always buy the "extended warranty" with used engines. They normally are 1 year warranties that supply you with a new engine and up to so many hours of labor covered up to the cost of the engine. They replace the engines/transmission for any reason, cause is not a concern. You won't make money on a reinstall, but hopefully you can atleast break even and keep a happy customer.

 

I am going to run this by my insurance agent soon to see if we would be covered under this. Like yourself, I have never had an insurance claim and it would irritate me if we had little to no coverage on something like this.

Edited by Mario
Posted

For used stuff I almost always start by contacting LQK. www.LKQonline.com They are one of the biggest suppliers of used parts in the country. They will deliver and pick up for free and if you have less than 100k on the engine it normally comes with a 12/12 warranty and of course the option of paying a little extra for the extended if you want it. They aren't always the cheapest but I have bought a bunch of stuff from them and the only time I have ever had a problem was with a VW transmission and they promptly replaced it with another one.

Posted (edited)

Yes lkq is a good company, we buy from them and always purchase the labor warranty. Usually 100-150 extra but great peace of mind for us and customer.

 

Most big yards post their inventory at car-part.com. I check there for most used parts.

Edited by Mario
Posted

So the vehicle is a 2006 Kia Sorrento suv with a 3.5 V6. After removing the timing covers to confirm the belt had jumped. The tech showed me that there is a small eccentric cam on the face of the tensioner pulley that requires a a special tool that you attach to a torque wrench and preload the tensioner pulley and then tighten fastener before releasing the holding pin from the tensioner. So it appears that the pretensioning step was not performed correctly because we didnt have the factory tool. I've never seen such a device built into a tensioner pulley. Very frustrated. Honestly it makes me not want to stick my head out by doing this kind of work.

Posted

I can't see that there's any money in a job like this for a small shop. We avoid jobs like this like the plague. Unfortunate that your techs let you down.

 

Sent from my SCH-I605 using Tapatalk

Posted

Main street america. They are more than happy to receive our 800 dollars per month. It's a new experience for me. I've been in business for almost 6 years and have had no problems of this kind. Call me naive but i really thought all these years that insurance would protect me from situations like this. Lesson learned and will move on but will be more cautious with this kind of work.

Posted

I told them that we installed a replacement engine and that we installed a new timing belt per the sellers warranty requirements and that the belt had jumped timing but didnt mention the pretensioning step that wasn't performed. It really doesn't matter to them as they don't cover our work as i found out. They only cover Property and medical damages that result from the work. The insurance company knows how to cover themselves best.

Posted

It all depends on what your policy is. I know we are covered for this type of situation. you should sit down with your agent and talk out scenarios and review your coverage. We at one time had a policy that would pay for subsequent damage but not the original "mistake". IE if a tech left a whell loose they would not pay for lugs or the wheel however they would pay for any damage caused by the wheel falling off. It cost an extra 40 bucks a year to cover the original mistake as well. a drop in the bucket and well worth the coverage imo.

Posted

This post made me review my insurance coverage, I thank you guys. I discovered I wasn't covered for any physical damage to my dealer cars. I'm not on a floor plan meaning i own (or owe someone personally) for my inventory. One big hail storm and I stand to lose half of my net worth. I added some coverage. On a side note I am reluctant to file a claim for anything so I have a high deductible which lowers the rates.

  • Like 2
Posted

It's always best to learn from other's mistakes. What is your deductible? Mine is 500. If a covered event happens. I think I'd rather have a higher deductible and a lower rate too.

  • Like 1
Posted

#1 don't warranty used parts. have customer sign paperwork stating no warranty.

#2 I hate to say it but one must go over all contracts you sign with your attorney or expect a surprise.

#3 been there done that- I'm always happy if no one gets hurt/killed. if I can solve the problem with money then I am happy.

  • 2 weeks later...
Posted

So the vehicle is a 2006 Kia Sorrento suv with a 3.5 V6. After removing the timing covers to confirm the belt had jumped. The tech showed me that there is a small eccentric cam on the face of the tensioner pulley that requires a a special tool that you attach to a torque wrench and preload the tensioner pulley and then tighten fastener before releasing the holding pin from the tensioner. So it appears that the pretensioning step was not performed correctly because we didnt have the factory tool. I've never seen such a device built into a tensioner pulley. Very frustrated. Honestly it makes me not want to stick my head out by doing this kind of work.

The rewards of doing the work is far greater than the penalties.
Posted

I must say it did feel very good to stand behind our work and happily hand the keys over to the female owner with a great running replacement engine. She was thankful that we handled it without any run around. What really felt great was being more professional than the insurance company. At least honest people with character and values can sleep at night.

Posted

Is the question about the insurance company? We had an incidence where a local shop built a driveshaft for a '66 Chevy Nova Wagon with a LS3 motor, etc. We spec'ed it out with the driveshaft company that the car will put approx. 600 hp to the wheels.

Well, they built it incorrectly with a smaller wall tube than they should have. We placed the car on the dyno for tuning.

On the first hard pull the engine twisted the driveshaft in half, taking out the motor, transmission and the entire floor pan. It was a rough day. I was sure I would pay for this out of pocket until I thought to call the insurance company.

 

The insurance company, Atain Insurance through SEMA, paid for the whole thing. The new engine, transmission, new driveshaft

(not from the old driveshaft company), floor pan and installation. They even paid us to put everything back together. Didn't quibble about anything.

 

How's that for service.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Available Subscriptions

  • Have you checked out Joe's Latest Blog?

         0 comments
      It always amazes me when I hear about a technician who quits one repair shop to go work at another shop for less money. I know you have heard of this too, and you’ve probably asked yourself, “Can this be true? And Why?” The answer rests within the culture of the company. More specifically, the boss, manager, or a toxic work environment literally pushed the technician out the door.
      While money and benefits tend to attract people to a company, it won’t keep them there. When a technician begins to look over the fence for greener grass, that is usually a sign that something is wrong within the workplace. It also means that his or her heart is probably already gone. If the issue is not resolved, no amount of money will keep that technician for the long term. The heart is always the first to leave. The last thing that leaves is the technician’s toolbox.
      Shop owners: Focus more on employee retention than acquisition. This is not to say that you should not be constantly recruiting. You should. What it does means is that once you hire someone, your job isn’t over, that’s when it begins. Get to know your technicians. Build strong relationships. Have frequent one-on-ones. Engage in meaningful conversation. Find what truly motivates your technicians. You may be surprised that while money is a motivator, it’s usually not the prime motivator.
      One last thing; the cost of technician turnover can be financially devastating. It also affects shop morale. Do all you can to create a workplace where technicians feel they are respected, recognized, and know that their work contributes to the overall success of the company. This will lead to improved morale and team spirit. Remember, when you see a technician’s toolbox rolling out of the bay on its way to another shop, the heart was most likely gone long before that.
  • Similar Topics

    • By Changing The Industry
      Why Every Vehicle Needs an Inspection #podcast #autorepairbusiness #automotivebusiness
    • By Joe Marconi

      Premium Member Content 

      This content is hidden to guests, one of the benefits of a paid membership. Please login or register to view this content.

    • By Changing The Industry
      Lessons Learned from Opening a New Shop #podcast #autorepairbusiness #automotivebusiness
    • By carmcapriotto
      Looking to unlock the true potential of your business? Discover how taking time to think can reveal new opportunities, boost creativity, and tackle challenges head-on. Learn how clarity breaks can help you refine your vision, focus on what truly matters, and transform your marketing strategy for better results.
      Get practical tips on clearing distractions, setting the right direction, and making the most of your time away from the daily grind. Ready to take your business to the next level? 
      Tune in now and see how a little time to think can make all the difference!
      Thank you to RepairPal for sponsoring The Auto Repair Marketing Podcast. Learn more about RepairPal at https://repairpal.com/shops
      Are you ready to convert clients to members? App Fueled specializes in creating custom apps tailored specifically for professional auto repair businesses. Visit Appfueled.com to get started today. Keep your shop top of mind on the mobile device they love.
      Lagniappe (Books, Links, Other Podcasts, etc)
      https://shopmarketingpros.com/125 
      https://www.eosworldwide.com/blog/101893-eos-take-clarity-break - EOS Clarity Break


      Clarity Break Starter Questions
      Sometimes it is highly effective to have no plan, no questions while sometimes you need some starter questions to get your mind rolling (example questions below)
      What would I do if I wasn’t afraid? Today, I am dreaming about…. What’s draining my energy right now? Who do you admire and why? What are they doing that you can do also? How do you practice caring for yourself?  What are you most proud of? What can you de-clutter physically or emotionally today/this weekend? What are your self-affirmations? Make a list of statements to remind yourself who you are, what your talents/skills are, and what you believe about yourself.


      Show Notes with Timestamps


      How To Get In Touch
      Group - Auto Repair Marketing Mastermind
      Website - shopmarketingpros.com 
      Facebook - facebook.com/shopmarketingpros 
      Get the Book - shopmarketingpros.com/book
      Instagram - @shopmarketingpros 
      Questions/Ideas - [email protected] 
      Click to go to the Podcast on Remarkable Results Radio
    • By Changing The Industry
      Mastering Employee Trust for New Businesses #podcast #autorepairbusiness #automotivebusiness


  • Our Sponsors



×
×
  • Create New...